Hi, sorry for this really silly question.
Im currently building a Tilt EQ based from the stock parametric eq and i cannot seem to figure how i can do this..
Control a knob from a knob, Ive tried using the GUI connectors from the MGUI inside the knob > out into the MGUI of the 2nd knob and the image follows but the 1st knob value doesn't change.
I basically want - Float (a) changes and float (b) decreases in value but at these values.
A- 0.50 - 0.75
B. 0.25 - 0.50
Hope i explained clearly, sorry for this silly question and thanks for any help!
Activity over the last 24 hours
New Posts 2 • New Topics 0 • New users 1
Knob controlling Knob/Values
Moderators: electrogear, exonerate
3 posts • Page 1 of 1
Knob controlling Knob/Values
by smokeysteve22 on Fri Oct 14, 2011 9:59 pm
- smokeysteve22
- essemer
- Posts: 19
- Joined: Wed Jul 13, 2011 4:59 pm
Re: Knob controlling Knob/Values
by infuzion on Fri Oct 14, 2011 10:49 pm
Range: look at "MinMax" module
Control one via second: Float data though "Float Switch"
Control one via second: Float data though "Float Switch"
Need help? First search the forum & WiKi, then post in the help forum with a clear topic, request, & OSM. Then please WiKi the correct solution. If you want my personal assistance, I charge by the hour or for an exchange of services.
- infuzion
- smstar
- Posts: 6163
- Joined: Wed May 04, 2005 8:02 pm
- Location: Earth, USA, CO, Denver
3 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest